Rod Pin Grinder for ACID POWDER

Rod Pin Grinder for Acid Powder is a crushing device commonly used in industrial production. Due to its excellent performance, it is widely used in the crushing operations of various materials. Although the efficiency of this work is very prominent, we still have to look at the machine, just like a normal machine, check the machine, eliminate the machine failure, make the machine more efficient and safely.

Rod Pin Grinder for ACID Powder temperature is also a factor affecting work efficiency. When the temperature of the working fluid is too high, the flow rate of the gas will increase. Take air as an example, the critical speed at room temperature is 320 m / sec, when the temperature rises to 480 ° C, the critical speed can be increased to 500 m / sec, that is, the kinetic energy increases by 150%. Therefore, increasing the temperature of the working fluid is conducive to improving pulverization. The pressure of the working fluid is the main parameters of the jet speed, but also the main parameters affecting the fineness of the break. Typically, the higher the pressure of the working fluid, the faster the speed, the greater the kinetic energy. When the titanium powder is pulverized by superheated steam, the vapor pressure is usually from 0.8 to 1.7 MPa, and generally pulverized calcined material is high, and the material after the pulverized surface is low.

ALPA seaweed feed Rod Pin Grinder for Acid Powder case sharing: The company is a seafarer enterprise in Yantai. It has been found in the breeding process. It can be used as sea guchenian feed after breeding. Save feed purchase the cost of. By comparing the long-term use of a Rod Pin Grinder for Acid Power, the cost of purchasing the feed can save the cost of the production line for several years. The company purchased our AlPa Rod Pin Grinder for Acid Powder.

Technical parameters:
finished particle size: D90: 400 目
Production capacity: 400kg / h

Rod Pin Grinder for Acid Powder should maintain and maintenance

1, use Before, check all the standard parts of the equipment to be tightened, the belt is tight.
2, the spindle operation direction must conform to the direction of the arrow shown on the protective cover, otherwise it will damage the equipment, and may cause human damage.
3, check the electrical appliance is not intact.
4. Check the hardware such as metal-free materials in the equipment crushing room, otherwise it will damage the tool, affect the equipment operation.
5, the material must be checked before crushing, and there is no metal material hard article to be mixed to prevent crash or cause combustion.
6, the oil cup on the device should often be injected into the lubricant to ensure that the equipment is operating normally.
7, stopIt is stopped before the machine, if it does not continue to be used, to remove the objects in the machine.
8. Check the tool with the screen on time is damaged. If it is damaged, it should be replaced first.
9. When using the timing, there is a small oscillation, so it is necessary to connect the handle to the handle to avoid accidents.

Shan dong alpa is a scientific and technological private enterprise producing various airflow pulverities, airflow mill, disc gantry pulverization machine, disc air thrower.