Ring Roller Grinder with coal

With the continuous advancement of pulverizer technology, Ring Roller Grinder with Coal has been familiar with it. Now the most popular crushing equipment is Ring Roller Grinder with coal. It has a wide variety, available for laboratory, home and factory use. It has a wide range of production, high energy consumption, high automation, and high classification quality.

Ring Roller Grinder with COAL technology is designed and manufactured by the classification wheel.

There are usually two classification wheels: metal and ceramics, for some magnetic pollution-sensitive materials, the ceramic grading wheel must be used, and the current market is commonly used in the market. Another silicon nitride ceramic has excellent machining properties, high temperature resistance, corrosion resistance, wear resistance, high strength, high adhesion, low density, low friction coefficient and self-lubricity.

The grading wheel can be widely used in powder refining and grading industries. At present, the maximum diameter of φ180 mm is currently reached, the highest operating speed is 12,000 rpm, and the normal service life is more than 1 year. It has been successfully applied to Downstream users, the application is good. The maximum use of this classification wheel is to prevent metal pollution, in addition, its specific graviz is 40% lower than zirconia ceramics, which can not only greatly reduce the energy consumption of the motor, but can greatly lower motor energy consumption. Under existing motors, overcons can be achieved to obtain finer particles.

Alpa White Carbon Black Ring Roller Grinder with Coal Case Sharing: The company is a company engaged in white carbon black production. A ultra-fine pulverization apparatus for producing two granular white carbon products can be generated in the production process. After investigation, we finally purchased our Alpa's Ring Roller Grinder with coal.

Technical parameters:
Finished granularity: D50: 6.78 D90: 12.8μm
Production capacity: 30kg

Ring Roller Grinder with COAL job safety application Basic requirements

1, When the crusher is working, the operator should stand in the tangent direction of the hammer rotation, and if you don't wear your gloves, your hands must exceed the safety line, not allowed to use iron and sticks instead of hand feed.
2, pulverizer and power unit should be installed firmly. If the equipment is fixed for a long time, it should be fixed on the cement; if the device is a mobile operation, the unit should be installed on the base made of angle iron, and ensure that the belt wheel groove of the power machine (diesel or electric motor) and the equipment is in the same Rotary plane.
3, after the equipment is installed, check the fastening of the fasteners of each part, if there is loose to tighten. At the same time, check if the leather belt looseness is appropriate.
4 Whether the power machine and the pulverizing machine are lubricated.
5, don't just replace the pulley, prevent the transition chamber to produce explosion, or the speed of the pulverizer is too low.
6. After the pulverizer starts, it should be idled by 2 to 3 minutes, no abnormal phenomenon, then press the work.
7. At any time, pay attention to the operation of the equipment, the feeding should be uniform, to prevent blocking bullies, do not have a long time overload. If there is found that vibration, noise, the bearing and the body temperature is too high, the outer spray, etc., should be closed immediately, and the fault can be eliminated.
8. When blocking occurs, it should be stopped immediately. It is strictly forbidden to use a wooden stick or hand to feed or pull out the feed to avoid the pulverizer to wound the arm or damage the machine.
9. If you crush a hard raw material, the operator must wear glasses.
10, the workplace should have a ventilator and strictly prohibit fireworks to prevent dust explosion from fire.

If there is a need for Ring Roller Grinder with Coal and the question, please contact us AlPa,