Pin Crusher for Carbon Microsphere

Most of the product production and processing in the current stage uses Pin Crusher for Carbon Microsphere to use Pin Crusher For Carbon Microsphere to perform product of products, which is one of the very common ways of processing, accompanied by the continuous improvement of scientific productivity, and the technology of grading equipment It is also imminent to replace. The performance and internal configuration of the grading device of the airflow must also keep the trend of the era to continue the upgrade of the product.

Pin Crusher for Carbon Microsphere forms a set of crushing systems. After the compressed air is dried, it is sprayed into the pulverizing chamber by the Lavar nozzle, and the material is repeatedly collided, friction, shear and pulverized, and the crushing material is pulled down with the wind turbulence. Airflow movement to the hierarchical region, under a powerful centrifugal force generated by high speed rotation, so that the crude material is separated, and the fine particles that meet the particle size requirements are collected by the grading wheel into the cyclone and the dust collector, and the crude particles drops to the pulverizer to continue pulverization. . Since Pin Crusher For Carbon Microsphere is simple, it is easy to manufacture, so it is widely used.

ALPA Airgel PIN CRUSHER for Carbon Microsphere Case Sharing: This customer is a high-tech enterprise in R \u0026 D, production and sales of nano-energy, fireproof, insulation insulation new materials, and it is necessary to use Crusher, multi-party examine finally purchased our Alpa's Pin Crusher for Carbon Microsphere.

Technical parameters:
Finished product particle size: D90: 15-30UM

Ultra Pin Crusher for Carbon Microsphere is a dry material super micro Crushing equipment is widely used in various industries. Let's take a brief introduction to its daily maintenance content.

1, when the bearing oil is high, it is necessary to stop checking the cause of the fault and removal immediately.
2, easy to wear parts should pay attention to the degree of wear, pay attention to and do the preparation for replacement of parts.
3, for the top surface of the chassis of the active device, it is necessary to remove dust and other debris avoiding the machine that cannot be broken, the active bearing cannot move on the chassis, causing an accident.
4, all loads of the machine are bearings, so good lubrication and bearings have a large relationship, it can directly affect the service life of the machine and the operating rate, so the amount of lubricating oil required to be injected should be reached. Good seal.
5, the sleeve is easy to make loose phenomenon, and it must be checked.check.
6. Note that the operation of each part of the machine is normal.
7. If the rotating gear is in operation, if there is a hitting sound, it should be stopped in time and remove the fault.

If you have any use of the Pin Crusher for Carbon Microsphere and the questions, please contact us AlPa,