Turbo Mill Machine of Anhydrous Citric Acid

In the rapid development of rapid development, many people have a certain understanding of Turbo Mill Machine of Anhydrous Citric ACID, and crusher technology is in an absolute leading position in the industry.

In the process of production, Turbo Mill Machine of Anhydrous Citric ACID mainly uses the freezing, filtration and drying of the compressed air, forms an ultrasonic air air flow through the nozzle inside the device. After a powerful pressure rotation into the grinding chamber, the material to be pulverized in the grinding chamber exhibits a fluidized form.

ALPA seaweed feed Turbo Mill Machine of anhydrous citric acid case sharing: The company is a seafarer enterprise in Yantai. It is found to be smashing the seaweed during breeding. After crushing, it can be used as a feed for sea cucumber. The cost of purchasing. By comparing a long-term use of Turbo Mill Machine Of Anhydrous Citric Acid, it is possible to purchase the feed for several years, which may save this production line. The company purchased our ALPA Turbo Mill Machine of Anhydrous Citric ACID.

Technical parameters:
Finished granularity: D90: 400 目
Production capacity: 400kg / h

During production, the temperature rise of the bearing must be checked frequently, when heaven When more than 50 ° C, the check is stopped, and the reason is to rule out the fault. When the new machine is running, the drive belt is easy to elongate, pay attention to adjust the proper looseness of the belt to ensure the work life of the belt. If the lifting piece should be checked frequently, replace the production quality and production in time. The blade, the bushing should often check the wear situation. If the wear is worn, the productivity decreases, and the particle size is roughly discovered to be replaced. The host and the grading flow bearing are lipomatic lubrication, using special lipids, the replacement period of the bearing is around three months, and the filling of the grease is 1/2 of the interior space in the bearing cavity. Otherwise, It will cause too high of the bearing temperature. The spiral feeder has changed the lipid period of half a year, and Cape Calcium-based grease. In the output shaft E, ie the pulley E, avoiding the weight of the weight, damage the part. It is strictly forbidden to turn the handle on the stop. The lubricating oil used in this regulator is used with N32 alkaline high-zinc high-grade anti-motor oil pressure oil, and the deceleration machine is 401 generally lubricating oil, and it is not necessary to use other machines. After four or five months, new oil should be replaced.

For more information, please pay attention to Shan Dong Alpa.Flow pulverizer.