Pin Pulverizer for Wear-Resistant Materials

Pin Pulverizer for Wear-Resistant Materials is good, only need to be produced in a smooth ground place, and low noise, which can avoid dust leakage in the pulverization process, which is favored by the powder industry.

Pin Pulverizer for Wear-Resistant Materials is also a factor in working efficiency. When the temperature of the working fluid is too high, the flow rate of the gas will increase. Take air as an example, the critical speed at room temperature is 320 m / sec, when the temperature rises to 480 ° C, the critical speed can be increased to 500 m / sec, that is, the kinetic energy increases by 150%. Therefore, increasing the temperature of the working fluid is conducive to improving pulverization. The pressure of the working fluid is the main parameters of the jet speed, but also the main parameters affecting the fineness of the break. Typically, the higher the pressure of the working fluid, the faster the speed, the greater the kinetic energy. When the titanium powder is pulverized by superheated steam, the vapor pressure is usually from 0.8 to 1.7 MPa, and generally pulverized calcined material is high, and the material after the pulverized surface is low.

ALPA Organic Pigment PIN PULVER for Wear-Resistant Materials Case Sharing: The company is a Taiwan chemical raw material enterprise. In 19 years, the company purchased a mechanical grinder for pulverizing organic pigments from our AlPa.
Technical parameters:
finished product particle size: D50 less than 325 mesh
Production capacity: 300kg

Pin Pulverizer for Wear-Resistant Materials is a crusher, any mechanical equipment Before use, there must be a certain precaution to check the precautions for operation, which will minimize the damage rate, then what is the precaution before using a jet ball mill? Here are some introductions.
1. Check whether the firmware is tight before use, whether the spindle direction is correct, so as not to damage the machine.
2, the pulverizer should be lubricated in accordance with the requirements so that the machine is operating normally.
3, the material cannot be mixed before the grinding machine is added to avoid damaging the pulverizer.
4, the pulverizer does not have foreign matter or debris. If it should be handled in time to avoid damage to the tool.
5. When using the crusher, if there is abnormality, it should be handled immediately to avoid a large loss.
6. If damage should be replaced immediately, certain components should be checked regularly.

Welcome everyone to browse Shandong AlPA website, company specializing in the production and development and service of PIN Pulverizer for Wear-Resistant Materials product technology, high-energy technical experts, professionalAfter-sales service team solved the worries of our customers.