Vibration Pulverizer of Wheat Husk

Due to the wide application of Vibration Pulverizer of Wheat Husk, the research and development of classified machines at home and abroad attaches great importance. In the current market, there is a great development space.

The Vibration Pulverizer of Wheat Husk is suitable for microfinishing machines of materials such as synthetic resins and instruments. It is different from the ordinary pulverizer. It is not only simply crushed such as impact force and cutting force, but also subject to a large amount of ultrasonic eddy current produced on the back of the blade and the vibration of high frequency pressure generated by the resulting material. Crushing can also be broken, viscous and elasticity under certain conditions. The raw material temperature of the machine increased, and the thermal material can be broken.

ALPA Water Available Feni50 Vibration Pulverizer of Wheat Husk case Share: This customer needs a device that can make ultrafine pulverized metal powder. Finally, we purchased our AlPA CSM710-V mechanical grinder.

Technical parameters:

Production capacity: 200-250kg


For long-term \"health\" of the equipment, we need to take some measures to protect it again.

1. First, the gap of the hammer screen can be adjusted: the friction on the screen changes varies from the distance between the material and the screen, and the friction is different. Improve the hammer speed and hammer material efficiency by adjusting the hammer net gap. However, during the production process, the screens they use are different, the raw materials are different, the hammer screening gap needs to be adjusted; in the crusher, the crusher is not very good at the beginning, but after a period of time Work, the particles inside the crusher also changes; in the grinding machine parts, the hammer head is easily worn, and the gap between the hammer head and the screen is increased, and the yield is also declining, it is difficult to maintain.

Of course, in order to test the yield of a crusher, for some of the raw materials, for some screen holes, in order to determine the appropriate hammer sieve gap and suction, the useful life of the screen and the hammer can be obtained in a short time. Very high grinding efficiency data. However, in the production of feed grinding, such specific measurement data, according to the operator's work experience, the technical content of the crusher itself is two things. People with enrichment of experience and labor experience also require higher operating costs. When the hammer is worn, the gap between the hammer and the sieve increases, the friction is reduced, and the abrasive efficiency is lowered.
2. Vibration Pulverizer of Wheat Husk mainly requires a reasonable use of reverse glitch: mainly to rush the side hair of the screen into the inside, greatly increase the friction, but this method is not used for a long time. After the globi polishing, the efficiency is lowered. It lasts for 30 minutes to 1 hour.
3.Put the friction piece into the Vibration Pulverizer of Wheat Husk: The friction piece has the effect of the material ring, but the effect is limited.First, the teeth of the friction plate are in front of the hammer head, the friction surface is small, and the hammer is long-lasting; if the sieve area is too small, the output screen area will be reduced.
For any of the equipment, daily maintenance can be performed in order to ensure that the equipment can run for a long time, so daily is critical to the maintenance of Vibration Pulverizer of Wheat Husk.


The above is to use the VIBration Pulverizer of Wheat Husk, you can pay more attention to us!