Turbo Mill for Glass Fiber

The airflow pulverizer plays a vital role in the current industrial production. In various major minerals, chemical industry, pharmaceutical industry, and food manufacturing industries are widely used. With the continuous development of airflow crushers, the various major industries are particularly medical, and the food industry puts forward new requirements in the pulverization process. It is desirable that the powder can be kept clean. In the manufacture of traditional airflow pulverizer, carbon steel, stainless steel is generally used as the lining material of the airflow pulverizer.

Under the action of the high-speed rotary impeller, the gas pressure flowing through the impeller increases, and the high pressure airflow flows out of the impeller, the fine particles are ejected. Since the blade of the rotary vane is designed as a bending, the inlet is large, the exit cross-sectional area is small, so the airflow pressure at the outlet is reduced, the speed increases, and the rotational flow is conducive to classification.
The grading point adjustment mechanism sets three adjustment rods and keeps its synchronous motion using the chain. When the adjustment rod moves up, the fine powder increases; when the adjustment rod moves down, the fine powder is reduced. The graded point can be continuously adjusted, and the performance of Turbo Mill for Glass Fiber can be adjusted steplessly. The granular weight of the grading weight can reach D97 ≤ 3 ≤ 150 microns, which is suitable for fine grading of dry micrometer products.
The setting of the control ring is to ensure that the control ring is formed between the control ring and the radial particles ring, and the stability of the airflow flow is controlled. The residual windlet inevitably introduces excess gas from the dry material, the temperature of the classification chamber is high, and the air can expand, and therefore designed a residual tightening to maintain the stability and balance of the graded indoor airflow.


ALPA Organic Pigments Turbo Mill for Glass Fiber Case Sharing: The company is a Taiwan chemical raw material enterprise. In 19 years, the company purchased a machine for smashing organic pigments from our AlPa. Grinder.
Technical parameters:
Finished particle size: D50 less than 325 mesh

How to correctly use Turbo Mill for Glass Fiber method
[ 123] First, prepare before booting the host, attachment machine, pipeline, and valve, whether it is intact, whether it works fine.
Second, open

1. Turn on the compressor power supply, the pressure valve and the main valve of the dust collector, then turn on the power switch of the powder machine, and turn on the power.
2. From the zero start grading wheel and gradually adjust to the specified speed.
3. Several wind turbine, cyclone separator discharge, dust removal, feed motor power, then turn onTotal power supply, set the inverter frequency, and then begins to break.
4. The particle size of the finished wheel can be adjusted by grading wheel frequencies and charging.
Third, the order of shutdown is: inverter - feeder - Main valve - Compressor - Stepper wheel Motor - Cyclone discharge, dust removal switch - Fan - Total Power - Air Compressor.
4, repair

1. The motor should be lubed regularly, but the grease should not be too large, the bearing temperature is too high.
2. Hierarchical impeller, spiral feeder, crushing nozzle wear should pay attention to check, belt tight and suitable.
3. After a crushing material, after a certain period of time, it is necessary to remove the viscosity of the chalk, so as not to block, thereby affecting the crushing effect.
4. After the filter bag, you should clean or replace it.
V. Note

1. When the discharge device is running, the unloading port cannot be extended to avoid accidents.
2. The rotational speed of the impeller must not exceed the specified requirements, otherwise the temperature is too high, the impeller, and the electric machine are damaged.
3. Regularly check the safety valve to ensure safety.
The company has consistently follows the management of standards, puts the quality in front of the production and service policy, and provides products and services to our customers with confidence and weighing airflow mills.