Cell Mill for Molybdenum Disilicide

Everyone knows that choosing a product or service, to understand from all aspects of the milling machine, service, quality, etc.

In terms of airflow milling, it is important to understand its operational rules, which is very important because only familiarize the procedure, can operate correctly.

1. The operation rules for Cell Mill for MolyBdenum Disilicide are as follows: Prepare materials before the preparation before the boot is received. Complete the site to clean the grocery. Check whether the transportation pipes and auxiliary equipment, whether the pipelines are blocked, leak or poor sealing, whether the auxiliary equipment is intact, whether it works normally. Whether there is a phenomenon that the material is accumulated in the outer casing and the separator, if the accumulated material is required. Whether the bearing is lubricated, whether it is lubricated in an appropriate place. Check if all pipes, fastening bolts, washers, spindles, and instruments are intact, normal and flexible.
Second, Cell Mill for MolyBDenum Disilicide starts the motor, control the current and time at starting, so that the device can start running. When the equipment is operating normally, the feed speed can be adjusted according to the properties of the material. Uniform continuous feed should not be large or small, thereby affecting the separation effect of the grinding machine, making the machine easily malfunction. During operation, if an abnormality occurs, stop checking immediately before the failure continues.
Third, the main procedures of Cell Mill for MolyBdenum Disilicide are as follows: After the material in the grinding machine housing is completely pulverized, the feed should be stopped and turned off the motor. After the machine is idling for 3 minutes, press the stop button to stop the machine. When the machine is completely stopped, open the check door and check the wear of the vessel. Fill in the corresponding production record, update the device status flag, which is convenient for the next use.



ALPA lithium iron phosphate Cell Mill for Molybdenum disilicide case share: This customer has expanded the production process by comparing the performance of our ALPA's phosphate phosphate special crusher. It is poor than the same type of equipment in other powder equipment companies at home and abroad, even in some aspects there are unique advantages. After experimenting, the company purchased the Cell Mill for MolyBdenum Disilicide.

Technical parameters:

Finished granularity: D50: 3μm
Production capacity: 400kg


Installation, operation and maintenance is three important factors using Cell Mill for MolyBDenum Disilicide. The wear and consumption of each operation has always been every start operation.Key factors. In order to use the airflow pulverizer for a long time, please adjust the open mode. Boot is a standard, for the first time to contact and use this kind of equipment, it is always a very strange state. In fact, it is very simple, the best way is to familiarize yourself with the consumer content on the instructions or have no use value. Timely specification and familiar. After each startup, check the airflow pulverizer in time to develop good usage habits. In the future, we don't need to pay attention to and familiarize.

The airflow pulverizer has improved and improved from the design and component combination, gave us a lot of help. It is good quality, but it is also declined for a long time without maintenance and maintenance. Check the operating components, electrical components, and transmission. Once an abnormality occurs, please repair it in time, without a fault, gas mill, prevent accidents.

Different models of milling machine performance, different granularity, different production efficiency, different production and production environment, the price of processing equipment is also different, customers can ask AlPA engineers to purchase appropriate Model and specification, welcome to inquire.