Vibration Mill of Carbon Fiber

Modern production not only pursues production and finished product quality, but also develops toward environmental protection. Especially in the comminution industry, the overall development trend of my country's Vibration Mill of Carbon Fiber technology is stable and developed to the focus, strong control, high quality.

In terms of airflow milling, it is important to understand its operational rules, which is very important because only familiarize the procedure, can operate correctly.
1. The operating rules of Vibration Mill of Carbon Fiber are as follows: After the preparation before the boot is received, the material is prepared. Complete the site to clean the grocery. Check whether the transportation pipes and auxiliary equipment, whether the pipelines are blocked, leak or poor sealing, whether the auxiliary equipment is intact, whether it works normally. Whether there is a phenomenon that the material is accumulated in the outer casing and the separator, if the accumulated material is required. Whether the bearing is lubricated, whether it is lubricated in an appropriate place. Check if all pipes, fastening bolts, washers, spindles, and instruments are intact, normal and flexible.
Second, the launch of Vibration Mill of Carbon Fiber first activates the motor, controls the current and time at starting, so that the device can start. When the equipment is operating normally, the feed speed can be adjusted according to the properties of the material. Uniform continuous feed should not be large or small, thereby affecting the separation effect of the grinding machine, making the machine easily malfunction. During operation, if an abnormality occurs, stop checking immediately before the failure continues.
Third, the main procedures of the shutdown and inspection of Vibration Mill of Carbon Fiber are as follows: After the material in the grinding machine housing is completely pulverized, it should stop the feed and turn off the motor. After the machine is idling for 3 minutes, press the stop button to stop the machine. When the machine is completely stopped, open the check door and check the wear of the vessel. Fill in the corresponding production record, update the device status flag, which is convenient for the next use.


ALPA Composite Powder Vibration Mill of Carbon Fibration: This customer is a renewable resource company, which needs to select a different particle size selection of composite powder, and it is necessary to select less than 30 μm. Ultrafine powder. Investigate a number of domestic grading equipment manufacturers, did not find the right equipment, and finally found the right equipment in our AlPa, and selected our vertical grading machine equipment. Product particle size: D97 ≤ 30μm hour yield: 80T
Welcome major composite powder manufacturers to visit, incompetent experiments.
Vibration Mill of Carbon Fiber has many coresAttachment, these attachments are also fragile parts. Once they don't pay attention to repairs, it will cause serious consequences, especially if the airflow milling spindle will cause downtime, and cannot estimate the output loss. The following sections describe the cause of gas flow grinding main axis.

The cause of the airflow grinding main shaft is easy to damage:

1. Since the pulverizer is a long-time crushing and ground bulk ore, the mechanical impact will cause fatigue damage to the spindle, if it is operated, the surface of the spindle Will wear, if you don't pay attention, cracks are generated.
2. The air supply will pass the airflower overload. When gas flow is used, you need to feed it properly, and each machine is limited. If this is exceeded, the component is easily damaged in the load operation, which will affect the overall service life of the airflow.

3. During mining and transportation, ore is often mixed with some waste metals. When these objects are in electromagnets at the upper portion of the belt, the electromagnet cannot be Excluding, causing these materials in ore and mud into gas flow, resulting in frequent iron, resulting in frequent impact on the spindle and other portions.

The above is why the Vibration Mill of Carbon Fiber spindle is easily damaged.


Shan dong alpa specializes in the production and development and service of Vibration Mill of Carbon Fiber product technology, welcome to consult. With a perfect quality, excellent service, the most affordable price, the company provides the best crusher products and services for customers.